ServerLink KVM over IP Module Manual de usuario descargar pdf (Pagina 88)

KVM over IP Module

88 / 99

• Thirdly, after the firmware has been stored, the panel will request you to reset the IP-KVM

manually. Half a minute after the reset, the IP-KVM will run with the new firmware version

and should be accessible. However, you are requested to login once again.

Warning

The three-stage firmware update process and complete consistency check are making

a mistake in updating the firmware almost impossible. However, only experienced

staff members or administrators should perform a firmware update. Make sure the

IP-KVM's power supply will not be interrupted!

5.6.4 Unit Reset

Figure 5-34 Unit Reset

This section allows you to reset specific parts of the device. This involves the both keyboard

and mouse, the video engine and the IP-KVM itself. Resetting the card itself is mainly needed

to activate a newly updated firmware. It will close all current connections to the administration

console and to the Remote Console.

The whole process will take about half a minute. Resetting sub devices (e.g. video engine) will

take some seconds only and does not result in closing connections. To reset a certain IP-KVM

functionality click on the button Reset.

Note: Only the super user is allowed to reset the IP-KVM.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 98 99

Sin comentarios

ServerLink KVM over IP Module Manual de usuario Pagina 88